Difference between revisions of "NixOS on ARM/Wandboard"
From NixOS Wiki
m (Adds breadcrumb) |
(Add note about content being out-of-date) |
||
Line 12: | Line 12: | ||
<!-- TODO : write intro paragraph --> | <!-- TODO : write intro paragraph --> | ||
== Status == | == Status == | ||
+ | |||
+ | {{outdated|Section refers to old user-provided images. Should be reviewed with cross-compilation, or native compilation through userspace emulation.}} | ||
'''@dezgeg''''s porting efforts to ARMv7 should work. | '''@dezgeg''''s porting efforts to ARMv7 should work. |
Revision as of 22:17, 26 December 2021
Wandboard Family | |
---|---|
Solo/Dual/Quad | |
Architecture | ARMv7 |
Status
@dezgeg's porting efforts to ARMv7 should work.
Board-specific installation notes
First follow the generic installation steps to get the installer image.
U-Boot and its SPL need to be copied to specific sectors on the microSD card with dd. Download U-Boot & SPL for the board (uboot-wandboard_defconfig-2017.03_u-boot.img
, uboot-wandboard_defconfig-2017.03_SPL
), and copy them to the correct location with (again, replace /dev/sdX with the correct path to the SD card device):
sudo dd if=uboot-wandboard_defconfig-2017.03_SPL of=/dev/sdX seek=1 bs=1k
sudo dd if=uboot-wandboard_defconfig-2017.03_u-boot.img of=/dev/sdX seek=69 bs=1k
Then, install using the installation and configuration steps.
Serial console
Notes about the boot process
Only serial console (via the DB-9 connector) is supported.